Hub
 
2024.3
You are viewing the documentation for an earlier version of Hub.
  1. Installation and Upgrade
  2. Configure the Network Interface Binding

Configure the Network Interface Binding

Last modified: 09 November 2023

By default, the Jetty servlet engine and HTTP server used in Hub bind on the 0.0.0.0 network interface. For security reasons, this action may be restricted in some environments.

note

Hub Docker Image

If you run the Hub service inside a Docker container, there is no need to change the listen-address. However, you can still do it, using configure command to change the listen-address property.

You can use the configure command to change the listen-address property for your Hub server. Execute this command on behalf of the same OS user that runs the Hub service. This command creates configuration files and folders. The Hub service user must have permission to access the files and folders that are created by this command.

To change the network interface binding for Hub, follow the specific instructions for your installation type:

To customize the network interface binding for a Docker image:

  1. Stop the Hub docker container:

    docker exec <containerId> stop

  2. Run the configure command:

    docker run --rm -it
-v <path to conf directory>:/opt/hub/conf \
-v <path to logs directory>:/opt/hub/logs \
jetbrains/hub:<version> \
configure --listen-address=<new network interface address>

  3. Start the Hub docker container:

    docker start <containerId>